Standards
AS 3740 is the line between a bathroom that lasts twenty years and one that leaks within two. What genuine waterproofing compliance looks like, and what to ask before they tile.
AS 3740 is the line between a bathroom that lasts twenty years and one that leaks within two. Most waterproofing failures aren't bad luck, they're shortcuts taken where no one can see them. Here's what genuine compliance looks like, and what to ask any builder before they tile.
AS 3740 is the Australian Standard for waterproofing of domestic wet areas. It sets out where membranes must go, how high they must rise, and how junctions and penetrations must be treated. It isn't a suggestion, compliant waterproofing of wet areas is a requirement, and on insured building work it's part of what protects the homeowner.
In practice, the parts that matter most are the ones you'll never see once the tiles are on:
A bathroom doesn't leak because of the tile. It leaks because of what's under the tile, and by then it's a demolition job, not a repair.
The fastest way to save a day on site is to skimp on the membrane: one coat instead of two, no bond breaker in the corners, the membrane stopped too low, or tiling before it has cured. None of it is visible at handover. All of it surfaces eighteen months later as a stain on the ceiling below.
At PR&D, waterproofing is photographed at the membrane stage and logged to your client portal before a single tile goes down, so the part you can't see is the part you can prove.
Compliant waterproofing of wet areas to AS 3740 is required, and on insured building work it forms part of the protections a homeowner relies on. A reputable builder will document it.
Cure times depend on the membrane product, but rushing this step is a common cause of failure. The membrane should be fully cured per the manufacturer's specification before tiling begins.
Tell us what you're planning. We'll give you an honest view of what's possible and how we'd approach it, no obligation.
Request a consultation